Ryobi DBJ50 Instrukcje Operacyjne Pobierz pdf (Strona 104)

Page 95 Power Equipment Usage Manual (Rev. 5/10)

19.2. Setup & Use – Plunge Router

CAUTION: Before connecting router to power source, ALWAYS MAKE SURE

SWITCH IS IN THE “OFF” POSITION.

19.2.1. Selecting the Bit

Routers are furnished with 1/4" and 1/2" diameter collets that will accommodate bits with 1/4" or 1/2"

diameter shanks that are installed directly into the power unit collet.

19.2.2. Installing & Removing the Bit

CAUTION: DISCONNECT TOOL FROM POWER SOURCE.

a. Remove motor unit from base unit as follows:

• Loosen clamp screw (A) Figure 1.

• While holding base, turn motor unit

COUNTERCLOCKWISE until lower pin (B) in

motor housing is disengaged from groove in

base.

• Lift motor unit free from base unit.

b. Clean and insert shank of bit into collet until shank bottoms. Then back it out approximately

3/8” to 1/2“.

c. Lay motor unit on its side on bench with the collet

pointing AWAY from you.

d. Place one wrench on flats on chuck with the opposite

end of the wrench resting on the bench to your left,

Figure 2.

e. Place other wrench on collet and tighten

COUNTERCLOCKWISE as shown in Figure 2. TIGHTEN

FIRMLY.

AVOID POSSIBLE DAMAGE TO COLLET. NEVER TIGHTEN COLLET WITHOUT BIT.

f. To remove the bit, reverse the foregoing procedure.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 138 139

Brak uwag

Ryobi DBJ50 Instrukcje Operacyjne Strona 104