Ryobi DBJ50 Instrukcje Operacyjne Pobierz pdf (Strona 79)

Page 70 Power Equipment Usage Manual (Rev. 5/10)

i. TURN THE MACHINE “OFF” AND WAIT FOR THE DRILL BIT OR CUTTING TOOL TO STOP TURNING

prior to cleaning the work area, removing debris, removing or securing workpiece, or changing

the angle of the table. A moving drill bit or cutting tool cause serious injury.

j. DO NOT drill length of a hole in one plunge. Take several small plunges. Never forcefully drive

the drill bit down and through the workpiece in one single pass. On thick wood, pull the bit back

out to clean out drill chips and prevent damage to the bit.

k. NEVER start the drill press with the drill bit or cutting tool in contact with the workpiece.

14.2. Setup & Use – Drill Press

Whether using one of the three larger floor standing drill presses or the smaller

bench standing drill press, the principles are the same.

14.2.1. Adjusting the Table & Depth Stop

Whenever you are adjusting or moving the table, support the table with one hand and do not rely totally

on the cranking mechanism for the required support.

Adjust the table or depth stop as shown below to drill consistant depth holes and to avoid drilling into

the table. Also, place a piece of scrap wood underneath the workpiece to protect the table.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 138 139

Brak uwag

Ryobi DBJ50 Instrukcje Operacyjne Strona 79