Ryobi AG452 Instrukcja Użytkownika Pobierz pdf (Strona 12)

WARNING:

Wire wheel brush bristles will bend during use and show

their direction of rotation. When reusing the wire wheel

brush, always mount it to rotate in the same direction

as in prior use. Failure to heed this warning can result in

bristle breaking and extreme vibration of the wire wheel

brush that could result in serious personal injury.

90˚ ROTATING HANDLE

See Figure 8.

The handle on the angle grinder can rotate 90˚ to the left or

the right for ease of operation.

To adjust the 90˚ rotating handle:

 Press and hold handle lock button.

 Rotate the handle to the desired position and release the

handle lock button.

NOTE: Make sure the handle lock button on the 90˚ rotating

handle clicks and locks into place when changing handle

positions.

Fig. 8

5° TO 15°

OPERATION

PUSH

HANDLE LOCK BUTTON

TO ROTATE HANDLE

Fig. 7

 Move the angle grinder back and forth or up and down

over the work area.

 Keep the angle grinder moving so that an excessive

amount of material is not removed from one area.

 If the angle grinder is held in one spot too long, it will

gouge and cut grooves in the workpiece.

 If the angle grinder is held at too sharp an angle, it will

also gouge the workpiece because of concentration of

pressure on a small area.

 Use just enough pressure to keep the angle grinder from

chattering or bouncing. Heavy pressure will decrease its

speed and put a strain on the motor.

 Normally the weight of the tool alone is adequate for most

grinding jobs.

 Use light pressure when grinding jagged edges or loose

bolts where there is the potential for the angle grinder to

snag on the metal edge.

 Lift the angle grinder away from the workpiece before

turning the angle grinder off.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag

Ryobi AG452 Instrukcja Użytkownika Strona 12

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Narzędzia Ryobi AG452