Ryobi Router Table A25RT02 Instrukcja Użytkownika Pobierz pdf (Strona 16)

Inch

inch

Inch

inch

FEED

DIRECTION

Inch

ASSEMBLY

ATTACHING THE VACUUM HOSE

See Figure 18.

The vacuum port molded into the fence will accept either a

1-1/4 in. or 2-1/2 in. vacuum attachment.

CLAMPING THE ROUTER TABLE TO A WORK

BENCH

See Figures 19.

 Unplug the router table and/or the router.

 Place the router table right side up on a sturdy work

surface; e.g., leg stand, workbench, counter top.

 Using a clamp, insert the top front of clamp through the

opening in the router table leg.

 Tighten clamp securely.

MOUNTING THE ROUTER TABLE TO A

WORK BENCH

See Figure 20.

 Unplug the router table and/or the router.

 Place the router table right side up on a sturdy work

surface; e.g., leg stand, workbench, counter top.

 Mark the holes with a pencil.

 Remove the router table.

 Drill four holes through the work surface.

 Place the router table back on the work surface, align-

ing the holes in the table legs with the holes in the work

surface.

NOTE: Position the router table surface at approximately

hip height.

 Insert four bolts (not included, 1/4-20 recommended) and

tighten securely with flat washers, lock washers, and hex

nuts (not included).

HEX NUT

WORK TABLE

FLAT

WASHER

LOCK

WASHER

CLAMP

WORK TABLE

VACUUM HOSE

VACUUM

PORT

Fig. 20

Fig. 19

BOLTS

Fig. 18

1 2 ... 11 12 13 14 15 16 17 18 19 20

Komentarze do niniejszej Instrukcji

Brak uwag

Ryobi Router Table A25RT02 Instrukcja Użytkownika Strona 16

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Routery Ryobi Router Table A25RT02