Ryobi TSS100L1 Instrukcja Użytkownika Pobierz pdf (Strona 20)

100

20 — English

MITER

TABLE

COMBINATION

SQUARE

BLADE

MITER

FENCE

ASSEMBLY

SCALE

INDICATOR

Fig. 22

INDICATOR

SCREW

BEVEL

SCALE

SQUARING THE BLADE TO THE MITER TABLE

See Figures 22 - 25.

 Unplug the saw.

 Pull the saw arm all the way down and engage the lock

pin to hold the saw arm in transport position.

 Loosen the miter lock handle approximately one-half turn.

 Rotate the miter table until the pointer on the control arm

is positioned at 0°. Securely tighten the miter lock handle.

 Loosen the bevel lock lever and set saw arm at 0° bevel

(blade set 90° to miter table). Tighten bevel lock lever.

 Place a combination square against the miter table and

the flat part of saw blade.

NOTE: Make sure that the square contacts the flat part

of the saw blade, not the blade teeth.

 Rotate the blade by hand and check the blade-to-table

alignment at several points.

 The edge of the square and the saw blade should be

parallel as shown in figure 23.

 If the top or bottom of the saw blade angles away from

the square as shown in figures 24 and 25, adjustments

are needed.

 Loosen the lock nut securing positive stop adjustment

screw. Also loosen bevel lock lever.

 Adjust positive stop adjustment screw to bring saw

blade into alignment with the square. See Positive Stop

Adjustment in the Adjustment section.

 Retighten bevel lock lever. Next, retighten lock nut

securing the positive stop adjustment screw. Recheck

blade-to-table alignment.

NOTE: The above procedure can be used to check blade

squareness of the saw blade to the miter table at both 0°

and 45° angles.

The saw has two scale indicators, one on the bevel scale

and one on the miter scale. After squaring adjustments have

been made, it may be necessary to loosen the indicator

screws and reset them to zero.

Fig. 23

CORRECT VIEW OF BLADE

SQUARE WITH MITER TABLE

VIEW OF BLADE NOT SQUARE WITH MITER TABLE,

ADJUSTMENTS ARE REQUIRED

Fig. 24

Fig. 25

VIEW OF BLADE NOT SQUARE WITH MITER TABLE,

ADJUSTMENTS ARE REQUIRED

MITER

TABLE

COMBINATION

SQUARE

BLADE

MITER

FENCE

POSITIVE STOP

ADJUSTMENT

SCREW

LOCK

NUT(S)

MITER

TABLE

MITER

LOCK HANDLE

COMBINATION

SQUARE

BLADE

MITER

FENCE

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 99 100

Komentarze do niniejszej Instrukcji

Brak uwag

Ryobi TSS100L1 Instrukcja Użytkownika Strona 20

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Piły elektryczne Ryobi TSS100L1